Hop-Up Alignment Kit v2.1 for AEG V2 with Wolverine Inferno 2 / Reaper 2 and Alpha 2026 Silent Industries

Version v2.1 of the hop-up alignment system, designed for AEG V2 replicas converted to HPA and compatible with Wolverine Inferno 2 / Reaper 2 engines in combination with the Alpha 2026 Silent Industries hop-up chamber.

This kit ensures precise alignment between the engine nozzle and the hop-up chamber, improving air seal, feeding consistency, and overall accuracy in demanding HPA builds. It is designed to provide a stable, clean, and easy-to-adjust installation.

Compatibility

Component	Compatibility
HPA Engine	Wolverine Inferno 2 / Reaper 2
Hop-Up Chamber	Alpha 2026 Silent Industries
Base Replica	AEG V2
Kit Version	v2.1
Configuration	HPA / AEG V2 Conversion

What's Included

• Rear retaining clip for secure installation.
• Main alignment base.
• Side guide for the HPA airline.
• Front locking top cap.
• System designed to keep the nozzle and hop-up chamber securely aligned.

Installation and Setup

1. Print all parts using the recommended settings.
2. Position the base inside the AEG V2 lower receiver.
3. Install the Wolverine engine and verify nozzle alignment.
4. Install the Alpha 2026 Silent Industries hop-up chamber with the inner barrel.
5. Fit the top locking cap to secure the assembly.
6. Route the HPA airline through the side guide.
7. Test fire and fine-tune the hop-up until the desired BB trajectory is achieved.

Required Components

• Compatible mounting hardware.
• Threaded inserts or mounting fixtures depending on the lower receiver version.
• Alpha 2026 Silent Industries hop-up chamber.
• Wolverine Inferno 2 or Reaper 2 engine.

Lower Receiver Recommendation

A rigid, well-fitted lower receiver is recommended to maximize assembly stability, especially in HPA configurations.

If preferred, the kit can also be adapted to a universal printed lower depending on the project setup.

3D Printing Settings

• Layer height: 0.10 mm – 0.15 mm.
• Recommended infill: 55% – 90%.
• Recommended material: PLA+ or an engineering-grade material depending on the intended use.
• Light sanding of contact surfaces is recommended for optimal fit.