The ergonomic trigger guard is the part located below the trigger that holds the finger in the trigger well.
The part has a groove for resting the finger.
To install the part, you need two springs identical to those found in a V2 gearbox on a select plate, and a 3mm M3 socket.
Baseboard M3x3mm
**How to assemble them: **
1- Place the part on the lower, with the open side facing the grip
2- Insert the rear pins with the round end facing the slot
3- Insert the first spring, causing the pins to spread apart and lock into place
4- Position the safety catch in its correct final position
5- Insert the front pin and spring, then secure with a 3mm M3 socket using an Allen wrench
6- Tighten the pin to close the gap
Recommended products
The most recent models added to the collection
